Download Print this page

Troubleshooting - Sharp FP-G50Y Operation Manual

Hide thumbs

Advertisement

TROUBLESHOOTING

Before calling for service, please review the Troubleshooting chart below, since the problem may not
be a unit malfunction.
SYMPTOM
Odours and smoke are not
removed.
The DUST AND ODOR SIGN
illuminates green even when the
air is impure.
The DUST AND ODOR SIGN illu-
minates
orange or red even when the air is
clean.
A clicking or ticking sound is heard
from the unit.
The discharged air has an odour.
The unit does not operate properly
when cigarette smoke is in the air.
The DUST AND ODOR SIGN is
turned off.
The DUST AND ODOR SIGN lights
change colour frequently.
OM_FP-G50Y_EN.indd Sec1:10
OM_FP-G50Y_EN.indd Sec1:10
REMEDY (not a malfunction)
• Replace the fi lters if they appear to be heavily soiled.
(Ref. E-9)
• The air could be impure at the time the unit was plugged in.
Unplug the unit, wait one minute, and plug the unit in again.
• Sensor operation is affected if the Dust and odor sensor
openings are dirty or clogged. Gently clean the Dust and odor
sensor openings.
(Ref. E-8).
• Clicking or ticking sounds may be audible when the unit is
generating ions.
• Check to see if the fi lters are heavily soiled.
• Clean or replace the fi lters.
• Plasmacluster Air Purifi ers emit small traces of ozone which
may produce an odour.
• Is the unit installed in a location that is diffi cult for the sensor to
detect cigarette smoke?
• Is the dust and odor sensor opening blocked or clogged?
(In this case, clean the opening.) (Ref. E-8)
• Check to see if the Lights OFF Mode selected.
Press
for 3 seconds to light On. (Ref. E-7)
Check to see if the SLEEP mode is selected.
The DUST AND ODOR/PLASMACLUSTER SIGN are turned off
automatically after the SLEEP mode is selected.
• The DUST AND ODOR SIGN lights automatically change
colours as impurities are detected by the Dust and odor sensor.
E-10
9/6/2559 BE 14:01
9/6/2559 BE 14:01

Advertisement

loading

  Related Manuals for Sharp FP-G50Y