Download Print this page

Advertisement

Quick Links

FP-A80M
"Plasmacluster" and "Device of a cluster of grapes" are
trademarks of Sharp Corporation.
* The number in this technology mark indicates an
approximate number of ions supplied into air of
3
1 cm
, which is measured around the center of a
room applicable floor area (at 1.2 m height above
the floor) when the product is placed close to a
wall at the MED mode setting.
AIR PURIFIER
OPERATION MANUAL

Advertisement

loading

Summary of Contents for Sharp FP-A80M

  • Page 1 FP-A80M AIR PURIFIER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. * The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm , which is measured around the center of a room applicable floor area (at 1.2 m height above...
  • Page 2 Please read before operating your new Air Purifi er Some odor ingredients absorbed by the fi lters may become separated and may be discharged through the air outlet and result in additional odor. Depending on the usage environment, especially when the product is used in a condition signifi cantly more severe than household use, this odor may become strong in a shorter period than expected.
  • Page 3: Table Of Contents

    *From that air is drawn through the filter system. Room size : 62m Thank you for purchasing the SHARP Air Pu- rifier. Please read this manual carefully. Be- fore using this product, be sure to read the section: “Important Safety Instructions.”...
  • Page 4: Important Safety Instructions

    Sharp authorized Service Center • Keep the product away from water. or similarly qualified persons in Do not operate the product in places order to avoid a hazard.
  • Page 5 television reception, try one or more of during its maintenance. the following measures: • Adjust or reposition the receiving INSTALLATION antenna. GUIDELINES • Increase the distance between the product and the radio or TV. • Avoid locations where the sensors are exposed to direct wind.
  • Page 6: Part Names

    PART NAMES ILLUSTRATIVE DIAGRAM Air Outlet Air Inlet Handle Main Unit HEPA Filter BACK Deodorizing Pre Filter Dust Sensor Date Label Power Cord Plug INCLUDED • Operation manual...
  • Page 7 MAIN UNIT DISPLAY 11 12 14 15 17 18 SHOWER Button / SHOWER Indicator Light (green) Plasmacluster ON / OFF Button / Plasmacluster ON / OFF Indicator Light (green) CHILD LOCK Button / CHILD LOCK Indicator Light (green) CLEAN SIGN The color changes according to the air condition.
  • Page 8: Filter Installation

    FILTER INSTALLATION Unplug the electrical cord before performing any maintenance. To maintain the quality of the fi lters, they are packed in plastic bags and installed in the main unit. Be sure to remove the fi lters from the plastic bags before using the unit. Remove the front Panel.
  • Page 9: Operation

    OPERATION Press to start / stop. CLEAN SIGN Unless the power cord has been unplugged, the operation starts in the previous mode it The Dust Sensor automatically moni- was operated in. tors dust pollution level and adjusts fan speed accordingly. Press to select fan speed.
  • Page 10: Maintenance

    MAINTENANCE Care Cycle : Whenever dust accumulates on the unit or every 1 month. CLEANING THE FILTERS CLEANING THE UNIT Turn off the unit, and unplug the Wipe with a dry, soft cloth. power cord. For stubborn stains or dirt, use a soft cloth dampened with warm water.
  • Page 11 FILTER REPLACEMENT GUIDELINES Filter life varies depending on the room environment, usage, and location of the unit. If dust or odor persists, replace the filter. (Refer to “Please read before operating your new Air Purifier”) Replacement timing • HEPA filter About 2 years after opening •...
  • Page 12: Troubleshooting

    TROUBLESHOOTING Before calling for service, please review the Troubleshooting chart below, since the problem may not be a unit malfunctions. PROBLEM SOLUTION (not a malfunction) The unit leaves smoke and • Clean or replace the filters as needed. (Refer to page 9) odors in the air.
  • Page 13: Specifications

    SPECIFICATIONS Model FP-A80M Power supply 220-240 V 50-60 Hz Fan Speed Adjustment Speed Rated Power (W) Operation Air flow (m /hour) Noise Level (dBA) Standby power (W) 0.75 Recommended Room Size (m High density Plasmacluster ion recommended room size (m...
  • Page 14 Memo...
  • Page 15 Memo...
  • Page 16 TINS-B446KKRZ 22C 1...