Woodstock W1862 Owner's Manual page 54

To.adjust.table.parallelism,.do.these.steps:
1.. DISCONNECT MACHINE FROM POWER!
2.. Remove cabinet panel and locate chain on underside
of table.
3.. Loosen idler sprocket (see Chain.Tension
instructions on Page.50).
4.. Move chain away from sprocket you want to adjust
so only that sprocket can be rotated independent of
chain.
Note:.If the left side of the table is too high, the
left two sprockets will need to be adjusted. Each
tooth on the sprocket represents .008" of vertical
movement as the cogs are turned. Make sure, as you
turn the sprockets, to keep an accurate tooth count
to ensure that the table is adjusted equally.
5.. Mark location of one tooth of sprocket that you are
adjusting.
6.. Carefully rotate sprocket (clockwise to lower table;
counterclockwise to raise table) just enough to
position next tooth at marked location, then fit
chain around sprocket again.
7.. Repeat Steps.4–6 with each sprocket that needs to
be adjusted until table-to-cutterhead clearance is
within 0.008" from one side to the other.
8.. Make sure chain is properly fitted on sprockets, then
re-tighten idler sprocket and lock bolts.
9.. If necessary, micro-adjust table position by loosening
cap screws shown in Figure.60 and raising or
lowering table until it is properly aligned with
cutterhead.
. Note:.This process may require adjusting the
columns on both the left and right hand sides until
you find the correct combination.
Model W1862/W1863 (For Machines Mfd. Since 02/19)
Figure.60. Location of table micro-
adjustment screws (one side shown only).
-52-