Table of Contents
Advertisement
Rotating/Replacing.
Cutterhead.Inserts.(W1863)
To. reduce. risk. of. shock. or.
accidental.
disconnect. machine. from. power.
before.adjustments,.maintenance,.
or.service.
The spiral cutterhead is equipped with indexable carbide
inserts that can each be rotated to reveal one of four
cutting edges. If one edge of the insert becomes dull or
damaged, simply rotate it 90° to reveal a fresh cutting
edge, as described on Page.35.
Items.Needed.
Phillips Screwdriver #2 .........................................1
Wrench or Socket 12mm, 13mm ..............................1
Torque Wrench ..................................................1
T-25 Torx Bit .....................................................1
Heavy Leather Gloves .................................... 1 Pair
Light Machine Oil ................................... As Needed
To.rotate.or.replace.a.spiral.cutterhead.insert,.do.
these.steps:
1.. DISCONNECT MACHINE FROM POWER!
2.. Remove dust port, top cover, and belt cover.
3.. Put on heavy leather gloves to protect your fingers
and hands.
4.. Remove any sawdust or debris from head of insert,
Torx screw, and surrounding area (see Figure.27).
5.. Remove Torx screw and insert, then clean all dust
and debris from both parts and cutterhead pocket.
Note:.Proper cleaning of insert, Torx screw, and
cutterhead pocket is critical to achieving a smooth
finish. Dirt or dust trapped between insert and
cutterhead will raise insert, and make marks on
your workpiece when planing.
Tip:.Use low-pressure compressed air or a vacuum
nozzle to clean out cutterhead pocket.
Model W1862/W1863 (For Machines Mfd. Since 02/19)
startup,.
always.
Qty
-34-
The.carbide.inserts.are.very.sharp.and.
can. quickly. cut. your. hands.. ALWAYS.
use. caution. and. heavy. leather. gloves.
when. handling. these. parts. to. reduce.
the.risk.of.personal.injury.
Torx Screw
Figure.27..W1863 cutterhead inserts and
Torx screws.
Cutterhead
Insert
Advertisement
Table of Contents
