Woodstock W1862 Owner's Manual page 35

Model W1862/W1863 (For Machines Mfd. Since 02/19)
7.. Jack.Screws: Insert hex wrench into access holes in
cutterhead (see Figure.24), and rotate jack screws
to raise or lower knife until it barely touches center
pad of knife-setting jig with all legs of jig still firmly
on cutterhead, then snug gib bolts enough to hold
knife in place without fully tightening gib bolts (see
Figure.25).
Springs:.Insert hex wrench into access holes in
cutterhead (see Figure.24), and remove jack screws.
Push down on knife jig until all legs of jig are firmly
on cutterhead and knife just touches center pad
of jig, then tighten gib bolts enough to hold knife
in place without fully tightening gib bolts (see
Figure.25).
8.. Incrementally snug gib bolts in an even manner,
starting at middle and working your way to ends by
alternating left and right, as illustrated in Figure.26.
9.. Repeat Step.8, snugging gib bolts a little more.
10. Repeat Step.8, this time fully tightening all gib
bolts.
11.. Repeat Steps.4–8 for remaining knives.
Jack
Screw
Access
Holes
Figure.24. Jack screw access holes in
Figure.25. Using knife-setting jig to set
5 3
Figure.26..Gib bolt tightening sequence.
-33-
cutterhead.
Knife-
Setting
Jig
Tightening
Gib Bolt
knife height.
4
1 2