Woodstock W1862 Owner's Manual page 42

Model W1862/W1863 (For Machines Mfd. Since 02/19)
Drive.Chain.&.Sprockets
Grease Type .................................. Synthetic Grease
Frequency ..................... Every 160 Hours of Operation
The infeed and outfeed rollers receive the transferred
power from the cutterhead through the drive chain
system on the right side of the machine, as shown in
Figure.39.
Remove the table height handwheel and the safety covers
attached to the inside of the drive chain cover, then
remove the cover to access these parts.
Use shop rags and mineral spirits to clean away any debris
Figure.39. Example of drive chains and
and grime, then brush on a light coat of multi-purpose
sprockets for infeed and outfeed rollers.
grease to the chain and sprockets.
Gearbox.Oil
Oil Type ...................................................ISO-320
Oil Amount ................................................ 20 Oz.
Frequency .................After First 20 Hours, Then Yearly
Note: We recommend that you replace the gearbox oil
Drain Plug
after the first 20 hours of operation. This is a normal
break-in procedure and will help maximize the service life
of the machine by flushing away any particles from the
break-in and manufacturing process.
Although it is not necessary to remove the drive chain
cover to access the fill and drain plugs, it is more
convenient to do so (see Figures.40–41). Replace the
Figure.40. Example of gearbox drain plug.
gearbox oil with ISO 320 or equivalent oil until it just
reaches the fill plug.
Fill Plug
Figure.41. Example of gearbox fill plug.
-40-