Table of Contents
Advertisement
Assembly
Before beginning the assembly process, refer to Items.
Needed.for.Setup and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the Test.Run.or connecting
the machine to power.
To.assemble.planer,.do.these.steps:
1.. W1863:.Attach each cast-iron extension table to
planer table with (3) M8-1.25 x 25 hex bolts (see
Figure.11). Do not fully tighten hex bolts at this
time.
W1862: Attach each roller extension table to planer
table with (3) M8-1.25 x 20 hex bolts and (3) 8mm
flat washers (see Figure.11). Do not fully tighten
hex bolts at this time.
2. Thread (3) M8-1.25 x 12 set screws into each
extension table at locations shown in Figure.11.
3. Using a straightedge as a guide, rotate set screws
until extension tables are aligned with main table,
then fully tighten hex bolts installed during Step.1.
.
Note: Bed rollers will give you a false reading
with your straightedge if they are raised above
table. Move them down or work around them when
leveling extension wings (refer to Bed Roller Height
on Page 29 for details).
4.. Insert key into keyway on handwheel shaft on top of
planer.
5.. Line up notch in handwheel bore with key, then slide
handwheel onto shaft.
6.. Slide LOW/HIGH direction label onto handwheel
shaft, and secure handwheel with 10mm flat washer
and M10-1.25 hex nut (see Figure.12).
7.. Thread handwheel handle into handwheel (see
Figure.12), and tighten with wrench.
8.. Attach dust port to planer with (6) M6-1 x 12 flange
bolts (see Figure.13).
Model W1862/W1863 (For Machines Mfd. Since 02/19)
x 3
W1862
W1863
Figure.11..Extension table mounting
Install Handle
Here
x 1
LOW/HIGH
Direction Label
Figure.12. Table elevation handwheel
x 6
Figure.13. Dust port installed.
-20-
x 3
x 3
x 3
locations.
installed.
Advertisement
Table of Contents
