Model W1862/W1863 (For Machines Mfd. Since 02/19)
6.. Rotate insert 90° and install so that a fresh cutting
edge faces outward (see Figure.28).
— When all four insert cutting edges have been used,
replace insert with a new one. Always position
new insert reference dot in same position to aid in
rotational sequencing.
7.. Lubricate Torx screw threads with a very small
amount of light machine oil, wipe excess off, and
torque screw to 50–55 inch/pounds.
.
Note: If too much oil is applied to the threads,
excess oil will attempt to squeeze out of the
threaded hole and raise insert during installation,
bringing it out of height alignment.
Figure.28..Insert rotating sequence.
-35-