Woodstock W1862 Owner's Manual page 32

Items.Needed.
Hex Wrench 3mm ...............................................1
Open-End Wrench 12mm.......................................1
Straightedge 36" ................................................1
Feeler Gauge Set ...............................................1
Rotacator (optional, Page.36) ................................1
To.adjust.bed.rollers,.do.these.steps:
1.. DISCONNECT MACHINE FROM POWER!
2. Completely lower table to give yourself enough room
to work.
3.. Loosen set screws (see Figure.20) above each of
four roller adjustment cams (there are two on each
side of planer).
4.. Rotate eccentric adjustment cams to raise or lower
bed rollers to desired height above table surface.
5.. Verify both sides of each roller are at the same
height, then re-tighten set screws to secure in place.
6.. Re-check roller heights to make sure they did not
change while being secured.
— If roller heights are not correct, repeat this
procedure until they are.
Model W1862/W1863 (For Machines Mfd. Since 02/19)
Qty
Figure.20. Bed roller height controls.
-30-
Set Screws
Adjustment
Cams