Table of Contents
Advertisement
10.. Loosen jam nuts and set screws on each side of
infeed roller (see Figure.51).
11.. Using a feeler gauge, adjust set screw so it is 0.040"
from roller bushing block (see Figure.51), then
tighten jam nut. Repeat on other side of infeed
roller.
12.. Repeat Steps.10–11 with outfeed roller, only adjust
the gaps to 0.020".
13.. Loosen jam nuts and set screws on each side of chip
breaker (see Figure.52).
14.. Using a feeler gauge, adjust set screw so it is 0.040"
from cross bar (see Figure.52), then tighten jam
nut. Repeat on other side of chip breaker.
15.. Re-install belt cover, top cover, drive chain cover,
and dust port.
Model W1862/W1863 (For Machines Mfd. Since 02/19)
Roller
Bushing
Block
Figure.51..Example of feeler gauge
location for adjusting infeed roller height
when using wood blocks (one of two
Jam Nut &
Set Screw
Cross Bar
Figure.52..Example of feeler gauge
locations for adjusting chip breaker height
when using wood blocks.
-46-
Insert Feeler
Gauge Here
Jam Nut
& Set Screw
locations shown).
Insert
Feeler
Gauge
Here
Advertisement
Table of Contents
