Denon S-5BD Service Manual page 18

2. Heat run & Version display mode
2.1. preparation
(1) Equipment used : Heat run disc (This operation may not work with any discs other than the heat run discs listed
(2) Unit setting :
2.2. procedure
(1) While pressing the SOURCE and
2.3. Heat run mode
(1) Press the 5 button and open a tray.
(2) Set a disc to the tray and press the 1 button once . The " 1 " and " 3 " indicators blinks alternately and heat run
operation starts.
DVD : After playback title-1 and title-10 of the disc, the tray opens and closes automatically, then playback the
title-1 and title-10 again.
CD/BD : The disc is played through once from title 1 through the last title, the tray opens and closes automatically,
then the disc is played through again from title 1 through the last title.
(3) This heat run operation continues automatically or it stops caused by an error. In case of some error, the following
error messages are displayed on the FL tube.
No.
1
2
3
4
5
6
2.4. Version display
When "No Disc", the FL display changes in the order given in item-2.5. Display Order each time you press the STATUS
button of remote control.
2.5. Display Order
Error information (Refer to 2.6. Error display)→ q Model destination information → w Model Region information
→ e Main-μcom version information→ r Main1st Boot Loader → t DSPversion information / Audio PLD
→ y GUI FPGA Config → u GUI Nios Program → i BD System-μcom version infomation
→ o BD System-μcom Gen number information → Q0 BD System-μcom Boot Loder → Q1 B/E version infomation
→ Q2 B/E Gen number information → Q3 B/E Boot Loder → Q4 B/E OS version information → Q5 F/E version information
→ Q6 F/E Gen number information → Q7 F/E Boot Loder → Q8 USB-μcom version information
No. Display item
Model destination
q
REGION BD
w
REGION DVD
Main-μcom
e
Main FLASH
below.)
CD : CD TEST DISC (TCD-HR01)
DVD : DVD TEST DISC (TDV-HR01)
BD : BD TEST DISC (TBD-HR01)
No spec other than the following procedure.
buttons simultaneously, plug the AC cord into a power outlet.
8
Error contents
Tray Error
Bad Disc
Search Error
Read Error
Communications error
Other (Front end error)
XX : E1, E2, E3,etc
S e r i a l
R e g i o n
M a i n
M a i n
18
FL display
ERROR 01
ERROR 02
ERROR 03
ERROR 04
ERROR 05
ERROR 06
X : A,B,C Y : 1, 2, 3, 4, 5, 6
Display
N o .
B D :
D V D :
: X X . X X
R O M : X X . X X
X X
X
Y