Denon S-5BD Service Manual page 17

SERVICE MODE s
Special mode setting button
No. Mode
1 Initialization mode
2 Heatrun & Version display mode
3 Displaying the protection history mode Displaying the protection history
4 KEY LOCK mode
5 Test mode
ON/STANDBY
1. Initial setting mode
1.1. preparation
(1) Equipment used: None
(2) Unit setting: No spec other than the following procedure.
1.2. procedure
b Initialize the BD player when µcom, peripheral parts of µcom, or MAIN P.W.B. unit has been replaced in servicing.
b All user setting will be lost and its factory setting will be restored when this initialization is made. Be sure to memorize
your setting for restoring again after the initialization.
(1) Plug the AC cord into a power outlet.
(2) While pressing SOURCE and 9 buttons simultaneously, press the ON/STANDBY button. FL tube all lit.
(3) Release your fingers from the SOURCE and 9 buttons.
(4) The display on the FL tube switches to "INITIALIZING" / "Please_Wait" → "BD/SD" / "INITIALIZING" →
"BD/SD" / "INITIALIZED" and initialization is completed.
z Afterwards, it enters the FIRST SETUP mode.
contents
Backup data initialization is carried out.
(Remove settings for Network Setup.)
Opration Heat run mode
Serial No. and firmware versions such as Main, Sub, DSP
are displayed in the FL manager.
Operations using main unit panel buttons or master volume
are rejected.
Operations using main unit panel buttons are rejected
Panel lock mode is cancelled.
Operations using remote control are rejected.
Operations using Tray open are rejected.
Pickup & Dirve Test.
17
Button Button
Entering the mode
A B
SOURCE ON/STANDBY button
9
SOURCE AC cord
8
ON/STANDBY button
5 8
AC cord
1 / 3
2
AC cord
2 9