Installation - Bell Excursion 39280 Owner's Manual

TONE/PULSE Switch - A switch
located on the rear side of the base unit,
which allows you to set the dialing mode
to either Tone dialing or Pulse(rotary)
dialing.
DC 9V jack - A jack located on the rear
side of the base unit used for connecting
the AC adaptor to the base unit.

INSTALLATION

CAUTION: USE ONLY THE
NICKEL CADMIUM(Ni-Cd)
BATTERY TYPE INCLUDED WITH
THIS UNIT. USE OF OTHER
BATTERY TYPES MAY CAUSE
INJURIES OR DAMAGE.
Battery Installation
1. Remove the battery compartment
cover of the handset by pressing the
top of the cover and sliding it down.
2. Connect the Ni-Cd battery pack
plug along the slot into the handset' s
battery connector as shown below.
Handset
Battery
Compartment
Ni-Cd
Battery
Pack
Battery
Connector
(Figure 1)
3. Insert the Ni-Cd battery pack into
the battery compartment.
4. Replace the battery compartment
cover by sliding it up towards the
handset.
NOTE: Use the type and size of Ni-Cd
battery pack, 3.6V, 450mAh. It is
recommended that the Ni-Cd battery
061703A-2
OWNER' S MANUAL # 39280 ver. 061703A-1
Page: 8
pack should be fully charged overnight
prior to initial use.
Belt Clip Installation
With the back of handset facing up,
insert one side of the belt clip hook into
the matching slots at the top side of
handset as shown in Figure2. Slide the
other hook until it locks into place from
the opposite side of the handset.
Wall Mounting (With a standard
AT&T or GTE modular wall jack)
You may choose to install the Telephone
base unit onto a wall.
Wall Mounting (Standard Wall Jack)
1.
2.
Red
wire
3.
Black
Wire
4.
ENGLISH VERSION
Belt clip hook
(Figure 2)
Connect the short telephone line
cord to the telephone line jack on
the rear of the base unit.
Insert the free end of the short line
cord through the hole of the
mounting bracket.
Insert the hooks of the mounting
bracket into the matching slots on
the back of the unit as shown in
Figure 3.
Press the two locks located on the
side of the mounting bracket until
the locking hooks snaps into the
8