Bell Excursion 39280 Owner's Manual page 13

programmed into the memory. Each 4-
second pause occupies one digit of the
available 16 digits per memory location.
Memory Dialing
You can store and recall up to 10
frequently called telephone numbers (up
to 16 digits each) from the handset.
Storing Telephone Numbers into
Memory
1. Ensure that the base unit IN USE
LED indicator is off and the handset
is in standby mode(IN USE/BATT
LOW LED indicator is off).
2. Press the MEMO button on the
handset.
3. Dial the phone number you want to
store.
4. Press the MEMO button again.
5. Press a memory location where you
want to store the phone number
(from 0 to 9). You will hear one
confirmation beep.
6. To store more phone numbers or
modify existing numbers in memory,
repeat steps 1-5.
NOTES:
•
The maximum number of digits that
can be stored for each phone
number is 16 digits both in pulse
and tone mode.
•
Pause can be programmed into a
memory dialing sequence. Each
pause occupies on digit. If you are
using a switchboard system to
access an outside line, press the
PAUSE button on the handset to
store a pause.
Dialing a Number from Memory
1. Pick up the handset and press the
TALK button. The handset IN
USE/BATT. LOW LED indicator
flashes while auto scanning for the
best channel available. A dial tone
will be heard when the IN
061703A-2
OWNER' S MANUAL # 39280 ver. 061703A-1
Page: 12
USE/BATT LOW LED indicator
lights solid.
2. Press the MEMO button.
3. Press the memory location (0-9) on
the keypad for the number you have
stored. The stored number will be
dialed automatically.
NOTE: If you have difficulty storing or
recalling numbers from memory, refer to
the "Troubleshooting" chart of this user
manual.
Changing Stored Phone Numbers
1. Follow the steps described in
"Storing Telephone Numbers into
Memory".
2. The new phone number will
automatically replace the previous
one.
PAGE Function
To alert the handset user or to locate the
misplaced handset, press the PAGE
button on the base unit. Pressing this
button will activate the handset to beep
for one (1) minute, provided that
handset is located within transmitting
NOTE: The base unit could page the
handset regardless if the handset ringer
is set either to ON or OFF.
RINGER ON/OFF SWITCH
You can set the handset to the following
settings:
•
ON - The handset rings when
receiving incoming calls. For
normal use, always set the switch to
this position.
•
OFF – Turns off the handset ringer.
NOTE: The handset will not ring when
the RINGER ON/OFF switch is set to
OFF.
ENGLISH VERSION
range. Press again to stop.
12