Product-Specific Safety Notices - Vertiv VP8841 Manual

Vertiv Intelligent Rack PDU

6.2. PRODUCT-SPECIFIC SAFETY NOTICES

The specific procedural safety precautions relating to this product are stated below.
6.2.1. GENERAL SAFETY
Safety is a serious matter and all precautions should to taken to guarantee a safe work and
operational environment. General safety precautions must be observed during all aspects of
operation, service, and repair of equipment described in this document. Failure to comply with
the safety warnings, procedures and guidelines as presented in this document is in violation of
the safety standards of design, manufacture, and intended use of this equipment.
You are responsible for following the safety guidelines and warnings presented in this docu-
ment for this equipment. Individuals using or maintaining Vertiv product(s) are expected to fol-
low all the noted warnings and safety precautions necessary for safe operation of the equip-
ment in your environment. Vertiv assumes no liability for failure to comply with these require-
ments.
6.2.2. LIVE CIRCUITS SAFETY
Operating personnel must:
•
Not remove equipment covers. Only Vertiv Authorized Service Personnel or other qualified
maintenance personnel may remove equipment covers for internal sub-assembly, or compo-
nent replacement, or any internal adjustment.
•
Not replace any equipment component with power applied to the line cord. Under certain con-
ditions, dangerous voltages may exist even with the input power cable disconnected. Any ex-
ceptions for 'Hot-Swap' modules will be specifically noted in this product document.
•
Always disconnect input power and discharge circuits before touching any sub-assembly of
circuit component.
6.2.3. EQUIPMENT GROUNDING
To minimize shock hazard, the equipment chassis and enclosure must be connected to an elec-
trical earth ground. The input power cable must be either plugged into an industry electrical
code compatible receptacle or wired directly into an electrical code compatible interface. The
equipment earth ground wire (typically green) must be firmly connected to the facility electrical
DANGER
HAZARDOUS VOLTAGE, CURRENT, AND ENERGY LEVELS ARE PRE-
SENT IN THIS PRODUCT. POWER SWITCHED CIRCUITS CAN HAVE
HAZARDOUS VOLTAGES PRESENT EVEN WHEN THE SWITCH IS IN
THE OFF POSITION. DO NOT OPERATE THE PRODUCT WITH ANY
COVER PLATE REMOVED. ALWAYS MAKE SURE THAT PRODUCT IS
FULLY ENCLOSED PRIOR TO USE.
Page 77