Using External Temperature Probes - Elcometer 319 S User Manual

7 TAKING A READING (continued)
The Elcometer 319 Model T has a 'Softkeys Locked' feature which
provides an additional level of security to prevent accidental
stopping of interval logging. When ' Softkeys Locked' is enabled, an
extra key press is required to stop interval logging.
To enable 'Softkeys Locked'; press Menu/Setup/Softkeys Locked
followed by 'Sel'.
To view the statistical analysis of the reading data, press the 'Batch'
softkey - see Section 11.2 'Batch Statistics' on page en-17 for further
information.

8 USING EXTERNAL TEMPERATURE PROBES

The Elcometer 319 can be fitted with an external, k-type
temperature probe for taking measurements over an extended
period of time - 'Interval Logging' (Model T) - or at locations remote
from the gauge.
For details of the external probes available from Elcometer, see
Section 15 'Spares & Accessories' on page en-21.
8.1 FITTING AND EXTERNAL TEMPERATURE PROBE
1 Open the rubber cover (a) which covers
the k-type probe connector at the top of
the gauge.
There is no need to switch off the gauge before

fitting an external temperature probe.
2 Push the external probe connector into the
socket; never force the connector into the
socket.
One side of the socket is wider than the other therefore, the external

probe connector will only fit into the socket one way.
Note: When an external probe is fitted, the in-built surface temperature probe is
deactivated.
www.elcometer.com
R
a
en-12