Elcometer 319 S User Manual page 10

6 SETTING LIMITS (continued)
 
5 Use the
to set or 'Esc' to cancel.
6 If required, repeat Steps 3-5 to set and enable a low limit value.
7 Repeat Steps 2-6 for each climatic parameter as required.
To set limits for a batch (Model T):
Limits can be set when a new batch is created. Once a reading is
saved into the batch, limits cannot be amended and limits cannot be
added.
1 Press Batch/New Batch/Limits.
 
2 Use the
press 'Sel'.
 
3 Use the
to enable the limit.
 
4 Use the
 
5 Use the
to set or 'Esc' to cancel.
6 If required, repeat Steps 3-5 to set and enable a low limit value.
7 Repeat Steps 2-6 for each climatic parameter as required.
Batch limits can be viewed at any time via Batch/Review Batches.

When the value of a parameter falls outside set and enabled limits;
the appropriate parameter icon flashes;

If a reading exceeds any set limits during measurement, it will be shown

flashing on the display, even if it has not been selected for display via
Menu/Setup/Display/Select Readings.
the alarm symbol is displayed next to the parameter;

the red LED flashes;

an audible alarm sounds ;

when in batching (Model T); a reading which exceeds a high

limit is marked
marked .
Note: When the value of the parameter returns within limits, the alarm status is
cleared automatically.
b
The volume of the alarm is determined by the beep volume set via Menu/Setup/Beep Volume
en-9
R
softkeys to set the required value and press 'Ok'
softkeys to highlight the required parameter and
softkeys to highlight 'High Limit on' and press 'Sel'
softkeys to highlight 'High Limit' and press 'Sel'.
softkeys to set the required value and press 'Ok'
b
and a reading which exceeds a low limit is
www.elcometer.com