Table of Contents
Advertisement
Chapter 2 : Installation
Connecting the Cables
Video (15-pin)
OSD
Your touchmonitor comes with two touchscreen connector cables:
Serial (RS-232) cable and USB cable (For Windows 98 computers
only.)
1. Before connecting the cables to your touchmonitor and PC, be
2. Connect the ferrite end of the video cable to the video connector
3. Connect the power cord to the AC connector on your touchmon-
4. Connect either the Serial cable or the USB cable. Do not connect
Elo LCD Touchmonitor User Guide - 12
USB
Serial (RS-232)
sure that the computer and the touchmonitor are turned off.
on your PC. Connect the other end of the video cable to the
touchmonitor. Secure the cable to your touchmonitor and PC by
turning the screws on the connector.
itor. To protect your equipment against risk of damage from
electrical surges in the power line, plug the touchmonitor's
power cord into a surge protector, and then connect the power
strip to a grounded (three-pronged) AC electrical outlet.
both cables.
If you are using a serial connection, connect the female
end of the serial (RS-232) cable to the serial port on the
back of your PC. Connect the male end of the cable to the
touchscreen connector on your touchmonitor.
AC Power
Advertisement
Table of Contents
