Reading Test; Reading Test Command - Opticon NLV-5201 User Manual

7.3

Reading Test

After tuning, use the test command to confirm whether installation condition and tuning work properly.
7.3.1

Reading Test Command

Reading test outputs 1 result after 10 times of imaging and reading each. And output this continuously.
To start / end reading test, use the following command.
Item Command
.V
Reading test
Start/End
.W
The reading test outputs following data continuously.
BANK 1:RATE 100[%]:TIME 25 - 26[ms]:123456789<CR>
BANK 1:RATE 100[%]:TIME 24 - 28[ms]:123456789<CR>
BANK 1:RATE 100[%]:TIME 24 - 27[ms]:123456789<CR>
BANK 1:RATE 100[%]:TIME 24 - 26[ms]:123456789<CR>
Bank Read rate in
No. 10 times
NLV-5201 User's Manual
1st
Start reading test.
End reading test.
Max/Min read time Read
in 10 times data
Tuning and Bank Function
Description
Line
break
Chapter-7
Remark
80