Ok/Ng Signal; Enable/Disable Ok/Ng Signal - Opticon NLV-5201 User Manual

6.2

OK/NG Signal

Loose end spec contains the output wires to signal the reading success. OK = a good read occurred.
NG = a no good read occurred.
6.2.1

Enable/Disable OK/NG signal

To enable/disable, use the settings below.
Item
Enable/Disable
OK/NG signal
The basic flow chart is shown below.
Disable
NLV-5201 User's Manual
1st
Command
[X*Q Enable OK/NG signal
[X*R Disable OK/NG signal
Reading start
Clear OK/NG signal
(Inactive)
Reading successes?
Successes
OK/NG Signal
Enable?
Enable
OK signal active
End
Description
Fail
OK/NG Signal
Enable?
Enable
Disable
NG signal active
Chapter-6
Reading and Timing
Default

73