Auto Trigger - Opticon NLV-5201 User Manual

2.8.2

Auto Trigger

Detect target
Status Description
Status
Read
Auto trigger standby
Auto trigger sleep
Reading operation stop*
* "Reading operation stop" is configured using commands. This cannot be done while using USB-HID interface.
NLV-5201 User's Manual
1st
Power-OFF
Power
applied
Detect target
Standby
[Auto Trigger]
Configured
(Default is 60 seconds)
Scanning completes
or
Time out
Read
Processes reading. Illumination fully ON
When the target is within the scan area and detected, the scanner
starts the reading mode. AIM pulses.
Auto-trigger mode will sleep after 60 seconds (default time). This sleep
time can be re-configured or disabled.
Operation of the scanner is stopped.
Non-Operation
Auto Trigger Sleep
Description
Chapter-2
Before Using
21