Rs-232C Basic Information; Baud Rate (Transfer Speed) - Opticon NLV-5201 User Manual

5.1.1

RS-232C Basic Information

Following are the RS-232C interface basic information.
Item
Transfer speed
Data length
Parity bit
Stop bit
Handshake
Other option
5.1.2

Baud Rate (Transfer Speed)

The baud rate is the rate at which bits are transmitted from the scanner to the host and vice versa.
Both the scanner and the host must be set to the same baud rate.
The following commands can be used to configure the baud rate. "Z2" (safe settings in non-volatile
memory) needs be used after these commands to activate and save the new configuration.
Item Command
Baud rate
NLV-5201 User's Manual
1st
Description
300 to 115200 bps
7/8 bits
None/Even/Odd
1/2 bits
None, BUSY/READY, Modem, ACK/NAK
Flow control, Inter character delay
Description
K1 300 bps
K2 600 bps
K3 1200 bps
K4 2400 bps
K5 4800 bps
K6 9600 bps
K7 19200 bps
K8 38400 bps
K9 57600 bps
SZ 115200 bps
Chapter-5
Interface
Default
9600 bps
8 bit
None
1 bit
None
Default Remark
Enabled only with
"Z2"

48