Removing From The Host Machine; Compartment; Removing The Compartment - Canon Paper Deck-V1 Service Manual

3.1 Removing from the Host
Machine

3.1.1 Compartment

3.1.1.1 Removing
Compartment
1) Place a stack of paper [3] (A: about 8 cm in height)
on the floor on which to place the deck [2], thus
preventing damage to the roll support plate [1].
[3]
[1]
2) Push the deck release grip to detach the deck from
its host machine. Then, push down the latch plate
[1] found at the rear left to open the compartment
[2].
[1]
(rear)
3) Remove the screw [1] and the stopper plate [2], and
pull out the compartment [3] to the front.
the
0009-2060
[2]
A
[3]
F-3-1
[2]
F-3-2
[2]
(left rear of the
compartment)
4) Remove the 3 screws [1], and detach the right cover
[2].
5) Remove the screw [1] of the harness guide,
disconnect the connector [2], and remove the 3 screws
[4] each on the right and left of the compartment rail
[3]; then, lift the compartment [5] slightly to detach it
toward the front.
6) Place the compartment [5] on the base you prepared
in step 1)
Chapter 3
[1]
[3]
F-3-3
[2]
[1]
F-3-4
3-1