Canon Paper Deck-V1 Service Manual page 54

Chapter 3
Do not remove the screws.
[1]
F-3-44
Use the 4 screws used to keep the front cover in
place when adjusting the position of the front cover
so that the gap A between the front cover and the
upper front cover is 3 +/-1 mm.
[1]
F-3-45
5) Remove the 4 screws [1], and detach the roll
support plate [2].
3-12
[2]
[2]
[2]
F-3-46
6) Remove the coupling shaft [1] and the E-ring [2];
then, detach the pulley cover [3].
7) Remove the 2 screws [4], and detach the left cable
fixing plate [5]; then, detach the outside lifter cable
[6].
8) Remove the 2 screws [7], and detach the right cable
fixing plate [8]; then, detach the inside lifter cable
[9].
9) Remove the 2 set screws [12] and detach the
outside pulley [11] to detach the inside lifter cable
[9] from the inside pulley [10].
[12]
[4] [5] [10] [11]
F-3-47
[1]
[6] [9]
[8] [7]
[3]
[2]
[1]