Removing The Pickup Clutch; Deck Main Motor; Removing The Rear Cover; Removing The Deck Main Motor (M101) - Canon Paper Deck-V1 Service Manual

Chapter 3
[1]
[2]
[2]
F-3-28
When mounting the deck pickup unit [3], be sure
to tighten the 3 screws shown in the figure first.
F-3-29
3.3.1.6 Removing the Pickup
Clutch
1) Disconnect the connector [1], and remove the E-
ring [2]; then, detach the deck pickup clutch [3].
[1]
[3]
[4]
[2]
F-3-30
3-8
[3]
[2]
[3]
Screws
0009-2084
[5]
When mounting the pickup clutch, be sure that the
clutch is fitted in the stop [4].
Moreover, be sure that the harness is hooked on the U-
groove [5] of the guide.

3.3.2 Deck Main Motor

3.3.2.1 Removing the Rear
Cover
1) Detach the deck from its host machine; then,
remove the 6 screws [1], and detach the rear cover [2].
[1]
[2]
[1]
F-3-31
3.3.2.2 Removing the Deck
Main Motor (M101)
1) Disconnect the connector [1], and remove the 2
screws [2]; then, detach the deck main motor [3]. At
this time, be sure to take care not to damage the gear
found at the tip of the motor spindle.
0009-2094
[1]
0009-2095