G Safety And Ompliance - Ultimaker 2 User Manual

G4. Safety and Compliance
Electromagnetic compatibility EM
This is a class product In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures
The Ultimaker can in very rare cases temporarily lose display function caused by ESD Dis
play function can be fully restored by turning the machine of and then on again
The EM test report of the Ultimaker is available on request at info ultimaker com
Electrical safety
The Ultimaker operates on
of the low voltage directive The power supply meets all E mark regulations and is protected
against short circuit overload over voltage and over temperature For more information con
cerning electrical safety aspects we refer you to the Mean Well E
the GS X power adaptors
Only use the Ultimaker with power supplies and cables supplied bij Ultimaker V
lways unplug the printer before maintenance or modiications
!
Mechanical safety
The Ultimaker contains many moving parts but the stepper motors do not have enough
power to cause serious injuries and moving gears have been covered Still it is advised to only
reach in the machine when it is turned of
lways unplug the printer before maintenance or modiications
!
Risk of burns
There is a potential risk of burns as the print head can reach temperatures of up to
the heated bed of up to
minum cover to prevent contact but still we advise against reaching in the machine when the
print head and or heated bed are hot
lways let the printer cool down for at least
!
modiications.
Health
The Ultimaker is designed to print with PL and
at your own risk
When printing S small concentrations of Styrene vapor can be released This can in some
cases cause headaches fatigue dizziness confusion drowsiness malaise diiculty in con
centrating and a feeling of intoxication Therefore good ventilation is required and long term
exposure should be avoided It is advisable to use a fume hood with active carbon iltering for
ductless extraction Fume extraction is mandatory for use in oices classrooms and alike
G Troubleshooting and support for the Ultimaker
volts Extra low voltage and is therefore outside the scope
The nozzle of the print head is mostly surrounded by an alu
onformity Declaration for
minutes before maintenance or
S ilaments The use of other materials is
and
43