D Leveling The Build Plate - Ultimaker 2 User Manual

D2. Leveling the build plate
If the build plate is too far away from the nozzle
your D print might not stick to the build plate
Equally if you adjust the build plate too close to the
nozzle the build plate can block the ilament from
extruding from
the nozzle
build plate
fter transportation you might want to level
NOTE:
your build plate to ensure your D prints stick well to
the build plate
How to level the build plate
When leveling the build plate you must follow the
step until on the display where the irst
step
4/21 control the height by rotating this but-
ton.
In the step you rotate
5/21
plate screw
under the build plate to
height between the nozzle and the build plate
you adjust a similar build plate screw on the
In 6/21
right hand side Rotating left means closer to the
nozzle.
In these steps the print head will automatically move through the Ultimaker
CAUTION:
uild plate will determine its destination by going up and down again
Now follow the display instruction
D First use of your Ultimaker
It can also scratch the
this left build
control the
and
4/21 5/21
ONTINUE when inished
lso the
20