F Hange Ilament And Material Feeder - Ultimaker 2 User Manual

hange ilament and material feeder
F3.
Removing ilament
In the Ultimaker the ilament material can be changed
steps there is no need to do this all by yourself because the Ultimaker helps you with
that.
Go to the
1. [MATERIAL]
to H NGE this can be done by turning the wheel next to the screen Press the button
Note irmware updates in the future may use a diferent terminology
Your Ultimaker will heat up so the material can be removed later When the required
2.
temperature is met the feeder will turn by itself and retract the ilament
Rewind the ilament on the ilament spool and make sure it cannot uncoil at a later
3.
moment secure with hole in spool tape or anything that works
Feeding material
When you took the ilament from the spool you
4.
can replace it with a new spool follow the
ons on the display
In the last step of the instructions we make sure
5.
that the printer knows what kind of material you
have inserted in your machine Select on the display
the material that is identiied on the spool
Clean material feeder
fter a lot of printing the wheel in the material
feeder can accumulate small plastic particles You
can clean this by blowing air on the wheel or using
simple brush.
F Maintenance for your Ultimaker
tab on the main menu of the display Press the button next go
instructi
s you have learned in previous
a
36