Ultimaker 2 User Manual page 23

You can ONTINUE
material is loaded until it reaches
bowden tube clip
The ilament is being pulled through the
14/21.
transparent bowden tube more quickly Wait until
the progress bar is full
Follow the instruction on the display When
15/21.
the ilament material exits from the nozzle click the
button to ONTINUE
Do not touch the extruder while it is
WARNING:
heating it is heating up to
Don t be surprised if the material that initially
NOTE:
comes out of the nozzle is not the color you expec
ted There s probably some ilament left inside the
nozzle This is caused by testing the Ultimaker
before packing
Wait until you see the color that you loaded comes
out of the nozzle before you
Follow the display instruction
sure you choose the right material this material type
is usually indicated on the ilament spool
Press the RE DY to choose the material 18/21.
onirm the selection by choosing
D First use of your Ultimaker
this step when the
13/21,
the irst
degrees celsius
ONTINUE
and 17/21. Make
16/21
YES or NO
23