D D Printing And Print Removal - Ultimaker 2 User Manual

D5. 3D printing and print removal
fter you have chosen your
print your Ultimaker will prepare itself and heat its
print head nozzle and build plate This can take up
to minutes
Do not touch the extruder while it is
WARNING:
heating and in use Temperatures can vary between
and degrees celsius
While printing the L D display will indicate the
progress of your print and the remaining time to
completion There is also on screen the
options and
[TUNE]
When your D print is inished the display will
indicate that the Ultimaker is cooling down The
progress bar indicates when it is safe to take out
your print
Do not touch the print inside the
WARNING:
Ultimaker while it is still cooling down Wait until
the display tells you Print Finished You can remo
ve the print Some parts are cooling down from a
temperature of max
be still very hot
Now your print and your Ultimaker is at a safe
temprature You can remove the print Select the
K TO MENU to start the next print
this screen you have the options to
and [MAINTENANCE].
TERIAL]
ecause you have completed the First run
wizard this is now your home menu every time you
start up your Ultimaker
and the
[ADVANCED]
set if you want to do the First run wizard again
D First use of your Ultimaker
Ultimaker Robot
ORT
.
degrees celcius and might
lso on
H NGE M
Under
[MAINTENANCE]
you can choose Factory re
to
25