Installation - Vemer Chronos RF Bianco User Manual

Keyboard
■
The keys carry out different functions on the basis of the instrument status and they
will be described step by step in this user manual.
Multipurpose keys are not built into the instrument, that is to say contemporary
pressures of 2 or more keys.
There are two types of pressure:
- brief pressures,
- long pressures, with duration higher than 3 seconds.
During the press of a button, the display is blue.
Attention: press the keys with your fingers, do not use sharp objects!
Attention: the keys are active only if the instrument is hooked to the base
Cleaning the display
■
To clean the display use a soft, lint-free cloth, without using excess force.
• Association between Chronos RF and remote actuator
Because the Chronos RF and a remote actuator can communicate correctly, it's
necessary to perform a procedure called "self-learning", during which the remote
actuator recognizes and stores the identity of Chronos RF.
To perform the self-learning proceed as follows:
1. Activate the channel configuration of the remote actuator (see the instructions).
The actuator remains in configuration mode for a pre-set time, within which it must
receive the configuration string from Chronos RF.
2. Insert the batteries in the Chronos RF, respecting the polarity indicated on the
instrument (to access the batteries compartment it's
necessary to unhook the thermostat from the base by
pressing the tab at the bottom of the instrument).
After about 3 seconds the Chronos RF initiates the
configuration procedure (indicated by (onf on the
display) followed by a short test procedure (indicated
by Test on the display) where Chronos RF sends the
sequence on-off-on-off to the actuator.
CHRONOS RF Radiofrequency digital chronothermostat User Manual

INSTALLATION

- 7 -