Table of Contents
Advertisement
Dealer Pre-Delivery Instructions Grain Cart
WHEEL NUTS
Check ALL wheel nuts for correct torque setting. (3/4"-400 Ft-Lbs, 22mm-640 Ft-Lbs)
Tighten as needed. Re-Check wheel nut torque settings during initial break in period
(during 1st, 2nd, 3rd loads, etc.), then periodically afterwards (every 10 hours of use for first
40 hours). Keep checking wheel nut settings until wheel nuts do not loosen. If wheel nuts
loosen and damage the surface of the wheel center, it will be impossible to keep them
tight. Failure to keep the wheel nuts tight could cause considerable damage to the grain
cart and surrounding area. To ensure that wheel nuts do not loosen, it may be helpful to
mark the location of one side of the nut and wheel rim with paint. This will help when
observing if any rotation of the nut occurs. It is the Dealer's responsibility to have wheel
nuts torqued to specification before delivery. Damage caused by failure to keep the wheel
nuts tight is not warrantable.
HITCH
Determine the hitch style of cart to be compatible with tractor. Tractor with hammer strap
(clevis type) should be used with grain carts equipped with a single prong (spade) hitch.
Tractors equipped with a single prong hitch (no hammer strap) should be used with grain
carts equipped with a double prong (clevis) hitch.
Be sure the tractor pin is at least 1/4" smaller in diameter than the pin hole in the grain cart
hitch to ensure enough free movement when traversing through uneven terrain.
POWER TAKE-OFF
Check for adequate clearance between telescoping PTO and tractor hitch. Suggested
clearance is 7 inches.
Check telescoping PTO for adequate extension. With the tractor hitched to the cart on flat
level ground, the PTO should have approximately 10 inches extended from the collapsed
(shortest) length.
HYDRAULIC CYLINDERS AND HOSES
Run all functions of the hydraulic cylinders and inspect fittings and seals for leakage. (use
cardboard or wood to check for hydraulic leaks)
UPPER AND LOWER AUGERS
Raise the auger to the unload position. Run the auger from the PTO or optional hydraulic
motor. If the top auger is misaligned with the bottom auger, you will hear a 'bang' as
the upper auger realigns itself with the lower auger. This is normal as the top auger has
dropped to engage the lower auger. Be sure that the top auger engages the lower auger.
Check bearing at top of auger. Be sure to have approximately 1/8" to 3/16" gap under/
between top auger bearing. If there is no gap under the bearing, or the gap is greater than
1/8" to 3/16", the bearing needs adjusted.
(Continued on Next Page)
3
Advertisement
Table of Contents
