Figure 1-5 F 201 Hazard Label Locations - Synrad f201 Operator's Manual

Laser Safety
F201 label locations (continued)
MADE IN THE U.S.A.
OEM version
MODEL #: MODELNUMBER
SERIAL #: SERIALNUMBER
MFG Month DD, YYYY
TESTED AT XX Volts
This laser component does not comply with standards for complete laser products as
.
Specified by 21 CFR 1040.10 or IEC 60825-1
4600 Campus Place, Mukilteo WA 98275 | 425.349.3500
AVOID EXPOSUR E
Invisible laser radiation
is emitted from
this ape rture.
F ron t
AVOID EXPOSURE
Invisible laser radiation
is emitted from
this aperture.

Figure 1-5 F 201 hazard label locations.

700 WATTS MAX
10200–10800 nm
CAUTION
CONDENSATION AND
WATER DAMAGE CAN
OCCUR IF COOLING WATER
IS BELOW DEW POINT.
SEE OPERATION MANUAL.
WATER-COOLED VERSION ONLY
OR
Insert metric or UNC Insert metric or UNC Do not use more than
fastener thru laser fastener thru mounting one fastener per mount-
ing foot. Doing so will
mount and spherical plate and spherical washer
washer set into threaded set into threaded metric damage the laser
mounting plate or UNC hole in laser mount
Rear
WARNING
Do not lift or pull on water fittings! Do not remove water fittings!
This may cause misalignment or water leaks.
If a water leak is discovered, please contact
Synrad customer service immediately.
This laser product is ma nufactured unde r
one or more of the following U.S . Patents :
4,805,182 5,065,405 6,195,379 6,603,794
4,837,772 5,215,864 6,198,758 6,614,826
5,008,894 5,602,865 6,198,759
Other U.S . and Inte rnational Patents pending .
DANGER-INVISIBLE LASER
RADIATION. AVOID EYE OR SKIN
EXPOSURE TO DIRECT OR
SCATTERED RADIATION
CLASS 4 LASER PRODUCT
EN-60825-1, 2014
Top
CAUTION
These RF Excited Lasers must be provided with a
pre-ionizing "Tickle" signal during standby or
laser "low" periods. This is automatically provided
with Synrad's UC Series power controller. This signal
keeps the plasma ionized during laser "low" periods
and facilitates breakdown and pulse to pulse fidelity.
Damage or malfunction may occur if this or
equivalent drive signals are not used. See manual
for tickle pulse specifications or contact factory.
WARNING
Do not remove water fittings!
Do not lift or pull on water fittings!
This may cause misalignment or water leaks.
If a water leak is discovered, please contact
Synrad customer service immediately.
This laser product is manufactured under
one or more of the following U.S. Patents:
6,195,379 6,198,758 6,198,759 6,603,794
6,614,826 7,480,323 9,031,110 9,197,028
Other U.S. and International Patents pending.
SYNRAD f201 Operator's Manual Version 3.2
17