Nortel DMS-100 Series General Description Manual page 106

3-38 Ringing in Series II peripherals
Figure 3-10 Summary of Single LCM ringing generator configuration change procedure
Check the
configurationin
table LCMINV
Post the LCM
Use SWRG to
get both units on
the correct RG
Busy unit 1
Perform
changes to the
RG
Change the
RNGTYPE to
unassigned in
table LCMINV
297-1001-131 Standard 06.01 October 2000
Change the tuple
to the desired
RNGTYPE
RTS the LCM
unit
TST the LCM
unit
Repeat this
procedure for
the other RG
You completed
this procedure
This flowchart provides a
summary of the procedure.
Use the instructions in the
step-action procedure that
follows this flowchart to
perform the procedure.