Advertisement
Quick Links
POWER ON:
Press and release the power button on the inside of the headset
housing, shown in Figure 1. A voice message in the earpiece will say "Headset #,
Battery Full/Half or Low" and the power light on the opposite side of the earpiece will
go on (See Figure 2).
POWER OFF:
Press and hold the power button on the inside of the headset
earpiece for approximately 3 seconds. A voice message in the earpiece will say
"Headset off," and the power light on the opposite side of the earpiece will go off.
Figure 2
CONFIGURE HEADSET:
powering the unit ON. Immediately release all buttons after pressing the power button. All of these settings have
associated voice prompts when applying the setting. Please listen to confirm desired setting:
•
Hands Free (HF) on / off – Press and hold "B" and UP arrow to turn on HF. Press and hold "B" and
DOWN arrow to turn HFoff.
•
Auto HF (AHF) – Press "A1" (or A2) and the UP arrow to turn on the Auto HF mode. Set the base Xcvr
switch K1-3 to on. When you power the unit off AHF mode is not saved.
•
Language selection – Press and hold "A1" and the DOWN arrow to toggle between English and another
language. Doing this again toggles back to first language.
•
Registration to Base – Set base to accept registration and power up HS6000 while holding "B". Hold the
HS6000 within 2 meters of the base. (Must be done before use, see Wireless I/Q operation manual)
•
Play Status – Press "A2" and DOWN arrow buttons. (e.g. "Headset #, Battery Full/Half/Low,
English/Espanol, Hands-free on/off, firmware version #")
If you have questions regarding the HS6000, please call HM Electronics, Inc. at (800)848-4468.
OPERATING INSTRUCTIONS
Power
Light
Start with power OFF and press any of the following button combinations while
DRAFT
October 3, 2005
Transmit
Light
VOLUME UP:
Lightly press the "VOL" up-arrow
button on the side of the earpiece. Each time it is
pressed, a short beep will be heard in the earpiece.
VOLUME DOWN:
Lightly press the "VOL" down-
arrow button on the side of the earpiece. Each time it is
pressed, a short beep will be heard in the earpiece.
DRAFT
Figure 1
Advertisement
Related Manuals for HME HS6000
Summary of Contents for HME HS6000
- Page 1 Doing this again toggles back to first language. • Registration to Base – Set base to accept registration and power up HS6000 while holding “B”. Hold the HS6000 within 2 meters of the base. (Must be done before use, see Wireless I/Q operation manual) •...
- Page 2 TO TALK TO CUSTOMERS: With your fingertip (not your fingernail), press and release either the A1 or the A2 button according to the instructions below, and speak into the microphone. When you have finished talking to the customer, press the A1 or A2 button again. The headset will automatically stop transmitting when the car drives away.
- Page 3 Figure 4 MAKING HEAD SIZE ADJUSTMENTS: You may adjust the head size of HS6000 for best fit. Adjustments are made using the adjuster behind the battery holder as show in Figure 4a. The adjuster ratchets in and out on a track to accommodate almost any head size.
- Page 4 The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications were met. Hereby, HM Electronics, Inc. declares that the HS6000 is in compliance with the essential requirements and other relevant provisions of R&TTE Directive 1999/5/EC.