Table of Contents
Advertisement
Quick Links
The HS400 Headset is a compact, wireless headset intended for use with the HME Wireless Drive-
Thru Audio System 400. The following instructions provide the proper use and care of the HS400.
I.
HS400 HEADSET FEATURES
II.
HOW TO WEAR THE HS400 HEADSET
• •
Wear microphone on right or left side
• •
Wear microphone near side of mouth
• •
To adjust microphone position hold microphone
boom at base and pivot boom up or down
HM ELECTRONICS, INC.
OPERATING INSTRUCTIONS
Figure 1. Headset features
14110 Stowe Drive, Poway, CA 92064 USA • Phone: 1-800-848-4468
HS400
Headset
microphone
Figure 2.
Correct wearing
of headset
Fax: (858) 552-0172
base of
boom
HME# 400511
Rev B 2/17/03
Advertisement
Table of Contents
Related Manuals for HME HS400
Summary of Contents for HME HS400
- Page 1 HS400 Headset OPERATING INSTRUCTIONS The HS400 Headset is a compact, wireless headset intended for use with the HME Wireless Drive- Thru Audio System 400. The following instructions provide the proper use and care of the HS400. HS400 HEADSET FEATURES Figure 1. Headset features HOW TO WEAR THE HS400 HEADSET •...
- Page 2 In the full-duplex mode, you can transmit and receive communication at the same time, as in a normal telephone conversation. The HS400 hands-free (HF) and auto hands-free (AHF) modes are both examples of full-duplex operation. In the HF mode, transmission and reception are activated by touching and releasing a button.
- Page 3 C. Talk to Customers 1. Single-Lane Operation (one base station operating one speaker post) a. Push-To-Talk Mode • • Customer begins speaking at speaker post or menu board • • Adjust customer’s voice level in headset if necessary • • Press and hold A1 or A2 button to speak to customer —...
- Page 4 Release to listen E. Change and Charge Batteries If you hear “Headset Battery Low” in your headset, the battery needs to be replaced and recharged. HS400 batteries need be recharged after 8 to 9 hours of normal use. 1. Change Batteries Battery release a.
- Page 5 The auto-hands-free feature allows only one operator to communicate with a customer in one drive-thru lane without pressing any buttons. CAUTION: Only one HS400 per lane can be set in the auto-hands-free mode, or interference will occur when a customer enters the drive-thru lane.
- Page 6 To save this channel setting, press the B button. You will hear “Channel (0 – 7) saved,” and you will be automatically returned to the configuration-settings mode. NOTE: If you do not press the B button, after 10 seconds the HS400 will be automatically returned to the configuration-settings mode.
- Page 7 WHAT TO DO IN CASE OF PROBLEMS If any problem occurs in operation of your HS400, replace the battery with a known-good battery. If the problem is not corrected, call HME Customer Support at 1-800-848-4468. VII. HOW TO CARE FOR THE EQUIPMENT A.
- Page 8 Dual color LED (red/green) FCC NOTICE HME wireless radio frequency systems are type-accepted in the United States under Part 90 of the Federal Communications Commission (FCC) Code of Federal Regulations, and type-approved in Canada by Industry and Science Canada. Because licensing depends on the system’s application, it is the user’s responsibility to apply for a license from the...
Need help?
Do you have a question about the HS400 and is the answer not in the manual?
Questions and answers