HME NEXEO HDX HS7000 Quick Start Manual

Advertisement

The HS7000 is an all-in-one headset used for communicating with employ-
ees and customers in a store or drive-thru lane environment. It uses one
rechargeable lithium-ion battery (BAT70). With moderate use in a typical
environment, the headset will operate for approximately eight hours on a
single battery charge. It will alert you when the battery charge is low.
HEADSET
Side View
Status
LED
Lane 1
Lane 2
Volume Up
Volume Down
Action
HME
Group Chat
Icon Label
Status LED Boom LED Status/Description (voice commands are initiated by saying "Ok Nexeo" first)
Lane 1
Green
Lane 2
Red
Volume
Up
Volume
Down
Group
Action
Notes: Both the Status and Boom LEDs flash slowly with alternating colors
Status LED
indicates a low battery. The low battery Status LED is also accompanied by audio prompts.
Voice commands can be used instead of tapping the keypad but must first be enabled on the Base Station. To use voice com-
mands, begin by saying "Ok Nexeo," then, once the Boom LED turns on white continue with a voice command (see above table
for specifics). Volume # levels are 1-15. (E.g., saying: "Ok Nexeo, volume 12," changes the volume level to 12. Mute is 0).
HM ELECTRONICS, INC.
2848 Whiptail Loop, Carlsbad, CA 92010 USA
Phone: 1-800-848-4468
Fax: 858-552-0172
Website: www.hme.com
Email: support@hme.com
Status
Raised sections on
LED
the bezel allow users
to identify keypad
buttons by touch.
Boom
LED
Fig. 1
Keypad Reference Table
Tap to talk to lane 1. The Status LED flashes green while the Boom LED turns on solid
Green
green. Tap again to stop. The Status LED turns solid; the Boom LED turns off.
Voice Command: "lane 1" (to listen only) or "talk to lane 1," or "change lane" if in lane 2
Tap to talk to lane 2. The Status LED flashes red while the Boom LED turns on solid red.
Red
Tap again to stop. The Status LED turns solid; the Boom LED turns off.
Voice Command: "lane 2" (to listen only) or "talk to lane 2," or "change lane" if in lane 1
Tap to increase volume (the headset beeps become louder as confirmation). Press and
hold to maximize volume to loudest. Voice Command: "volume up" or "volume #"
Tap to decrease volume (the headset beeps become quieter as confirmation). Press and
hold to minimize volume to quietest. Voice Command: "volume down" or "volume #"
Tap for group chat. Both Status and Boom LEDs flash quickly, alternating red & green.
Tap again to stop.
No function. Reserved for future functionality.
Quick Start Guide
NEXEO | HDX™ HS7000 AIO HEADSET
HEADSET
Front View
Battery Release
Latch (silver)
Power Button
(blue)
Earpad
BAT70 Battery
(not included)
when the headset needs to be paired. A yellow
HME# PUB - 00072
Rev C 02/04/22

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NEXEO HDX HS7000 and is the answer not in the manual?

Questions and answers

Summary of Contents for HME NEXEO HDX HS7000

  • Page 1 "Ok Nexeo," then, once the Boom LED turns on white continue with a voice command (see above table for specifics). Volume # levels are 1-15. (E.g., saying: "Ok Nexeo, volume 12," changes the volume level to 12. Mute is 0). HM ELECTRONICS, INC. HME# PUB - 00072 2848 Whiptail Loop, Carlsbad, CA 92010 USA Rev C 02/04/22...
  • Page 2 Operating Temperature range: 0°C (32°F) to +50°C (+122°F) Compliance See NEXEO | HDX - Regulatory, Compliance, and Safety Guide online The HME logo and product names are registered trademarks or trademarks of HM Electronics, Inc. © 2022 HM Electronics, Inc. All rights reserved.

Table of Contents