Qualifier Signal Level Meter - General Specifications
Tuning range
Amplitude range
Amplitude accuracy
Analog Television Types
Digital Modulation Types
Tuning increments
Tuning accuracy
Auto-seeking range
(Direct access) quick-tuned
channels
Step-tuned channels
Pre-loaded channel sets
Audio Output
Qualifier Mode
Frequency
Activation Distance
Power
Battery
Battery recharge life
Size / Weight
Size
Weight
Environment
Storage temperature range
Operating temperature range
Humidity
Shock
Qualifier Transmitter - General Specifications
RF Output Power
Frequency
Input Supply Voltage
Size
Weight
Storage Temperature
Operating Temperature
Humidity
*Beginning with a new, fully charged battery. Room temperature lab tests produced more than 1,100 measurements by
repeatedly activating F1through F6 at 10 second intervals until automatic shut-down occurred.
Specifications - Qualifier System
5.00 MHz ~ 860.00 MHz
-30 dBmV (+30 dBmV) ~ +40 dBmV (99.9 dBmV)
±1.0 dB at room temperature; ±1.5 dB over operating temperature
NTSC / PAL; peak carrier sync, preprogrammed audio offset
QPSK, QPR, QAM, and VSB; bandwidth up to 20 MHz
Fixed (tuned by pre-loaded tables)
Auto-seeking to ≤ 62.5 kHz
±312 kHz
6 channels - user-configurable (factory pre-sets per Country Set)
Pre-loaded channel set dependent
25 standard, picture carrier plus associated sound carrier
Frequency modulation detector produces low impedance output to
earphone jack (earphone optional)
27.450, 27.470, or 27.490 MHz
Up to 150 feet between receiver and transmitter
User rechargeable, 6.0 V @ 0.55 Ah
> 550 measurements*
7.7" high X 3.5" wide X 2.3" deep (19.6 cm X 8.9 cm X 5.8 cm)
23 oz. (0.65 kg)
-20 °F ~ 150 °F (-29 °C ~ 66 °C)
0 °F ~ 120°F (-18 °C ~ 49 °C)
Weather resistant (withstands total immersion into 1 foot of water for
30 minutes without intrusion)
Uniquely rugged
5 watts
Factory set to 27.450, 27.470, or 27.490 MHz
Vehicle power - 12 volts DC negative ground
7.7" x 4.4" x 1.7" less connectors and mounting bracket
2.5 lb
-20°F ~ 150°F
0°F ~ 120°F
5% ~ 95% (non condensing)
iii
Qualifier System
Need help?
Do you have a question about the CyberTek QUALIFIER and is the answer not in the manual?