Converting Voltage
to 220V
For your own safety, and to maintain the warranty
for the machine, the voltage conversion MUST be
performed by an electrician or qualified service
personnel.
The voltage conversion procedure consists of
installing the correct plug, rewiring the motor, and
replacing the 110V circuit board with a 220V circuit
board. The 220V circuit board (part #P0777054)
can be purchased by calling Grizzly Customer
Service at (800) 523-4777.
Wiring diagrams are provided on Pages 50–51
for your reference.
IMPORTANT: If the diagram included on the
motor conflicts with the ones on Pages 50–51, the
motor may have changed since the manual was
printed. Use the diagram included on the motor
instead.
Items Needed
•
Phillips Head Screwdriver #2 ..................... 1
•
Electrical Tape ............................ As Needed
•
Wire Nut (14 AWG x 3) ............................... 1
•
Plug 6-15 .................................................... 1
•
Wire Cutters/Stripper .................................. 1
-16-
To convert Model G0777/G0777HEP to 220V:
1.
DISCONNECT MACHINE FROM POWER!
2.
Cut 110V plug from power cord.
3.
Remove four screws that secure remote
control receiver panel to control box (see
Figure 8).
Figure 8. Remote receiver panel screws.
4.
Remove wire nuts indicated in Figure 9.
Qty
Remove
Figure 9. Motor wires at 110V.
Model G0777/G0777HEP (Mfd. Since 04/19)
Start
Run
Capacitor
Capacitor
400MFD
60MFD
125VAC
250VAC
1
4
3
2
Remove