Grizzly G0777 Owner's Manual page 19

5. Use wire nuts to connect wires, as indicated
in Figure 10. Twist wire nuts onto their
respective wires and wrap them with electri-
cal tape so they will not come loose from
vibration of motor operation.
Start
Capacitor
400MFD
125VAC
1
Re-Connect
and Tighten
Figure 10. Motor wires repositioned for 220V.
6.
Remove wires connected to circuit board, as
indicated in Figure 11.
7.
Remove three screws indicated by short
black arrows on 110V circuit board (see
Figure 11), remove circuit board, then install
220V circuit board with three screws.
Remove
Wires
SF1101-1
9908
CIRCUIT
BOARD
Figure 11. Location of wires to remove from
circuit board.
Model G0777/G0777HEP (Mfd. Since 04/19)
Run
Capacitor
60MFD
250VAC
3 2
Re-Connect
4
and Tighten
Remove
Wires
8. Re-connect wires removed in Step 6 to 220V
circuit board exactly as they were connected
to 110V circuit board.
9.
Re-install remote control receiver panel with
screws removed in Step 3.
10. Install a NEMA 6-15 plug, according to manu-
facturer's instructions included with plug. If
no instructions were included, use wiring
diagram on Page 50.
-17-