Dexter Laundry T-350 Operator's Manual page 31

CONTROL BOARD
Condition
Action
Exit
GRAPHICS BOARD
Condition
Action
Exit
MODEL JUMPER MISSING
Condition
Action
Exit
MODEL JUMPER CHANGED
Condition
Action
8514-290-001 REV B page 31
return the Machine to Idle Mode.
This error occurs when the Main Control Board cannot command
the input and outputs of the control system as required by the
cycle programming.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error Code and
return the Machine to Idle Mode. If the prompt to Reset is not
available, power must be cycled to the machine to reset the error.
This error occurs when the Graphics Board cannot command the
Main Control board as required by the cycle programming.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error Code and
return the Machine to Idle Mode. If the prompt to Reset is not
available, power must be cycled to the machine to reset the error.
This error occurs when there is no connection to Ground (Pin 7)
on the Model Jumper Header.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met. The
machine control checks for this condition when power is cycled
and before starting every machine cycle.
The machine will not start and the Error Code will continue to be
displayed until the condition no longer exists and the prompt is
followed to Reset the Error Code and return the Machine to Idle
Mode.
This error occurs when the jumper connections to Ground (Pin 7)
on the Model Jumper Header have changed since the last control
check.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met. The