Dexter Laundry T-350 Operator's Manual page 30

Exit
Note
HEAT RISE OUT OF RANGE
Condition
Action
Exit
Note
NO PROX SENSOR OUTPUT
Condition
Action
Exit
PROX SENSOR OUT OF RANGE
Condition
Action
Exit
8514-290-001 REV B page 30
The Error Code will continue to be displayed until the in-progress
cycle is stopped and the control is returned to Idle Mode. It will
then reset automatically.
This error code is disabled if the washer model does not have an
Auxiliary Heating option
This error occurs when the control detects that the operating
temperature is greater than 220 degrees F (or 104 degrees C).
When detected, the control will display the "HEAT RISE OUT OF
RANGE" prompt, alternating with the normal Cycle Progress
screen at a rate of 5 seconds on, 5 seconds off. The heating relay
will also be turned off. Otherwise the cycle will continue normally.
There is no delay in the action once the criteria are met.
The Error Code will continue to be displayed until the in-progress
cycle is stopped and the control is returned to Idle Mode. It will
then reset automatically.
This error code is disabled if the washer model does not have an
Auxiliary Heating option
This error occurs when the machine control does not detect
output from the proximity sensor(s) when the cylinder has been
commanded to turn.
When detected, there is a short delay before the error is active.
When active, the control turns off the motor and all relays.
The machine will not start and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error Code and
return the Machine to Idle Mode.
This error occurs when the machine control sees output from the
proximity sensor(s) that does not fall in the acceptable range for
the particular washer or dryer model running at normal speeds.
It also occurs when the machine control sees output from the
proximity sensor that implies the tumbler is still turning when the
control has commanded it to Stop.
When detected, there is a short delay before the error is active.
When active, the control turns off the motor and all relays.
The machine will not start and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error Code and