Table of Contents
Advertisement
____________________________________________________________________________________________________________
AutoPing Commands
Command
get autoping
set autoping < 1 | 2 > ipaddress < dotted decimal >
set autoping < 1 | 2 > frequency < 1-999 >
set autoping < 1 | 2 > failcount < 1-999 >
set autoping mode < single | and | or >
set autoping action < none | on-latch | on-follow | off-latch |
off-follow | cycle | cycle-once >
User Commands
Command
set password < user | admin > < old > < new > < repeat >
© 2019 AMETEK Electronic Systems Protection | Technical Support 1-800-645-9721 | surgex.com
SA-20-AR
Description
Returns all AutoPing settings currently in use. Example:
AutoPing 1
AutoPing 2
IP Address:
10.1.2.36
0.0.0.0
Frequency:
60
10
Fail Count:
3
3
Status:
OK
OK
Trigger Count: 0
0
--------------------------------------
Mode:
Single
Action:
On-Latch
Ok
Sets the IP address to be pinged for AutoPing 1 or 2.
Sets the frequency (how often the ping is sent) for
AutoPing 1 or 2 in seconds.
Sets the number of consecutive failures the AutoPings
must detect before the AutoPing considers the pinged
device to be failed.
Sets single AutoPing (AutoPing 1) or two AutoPing
relationship AND or OR.
Sets the action to be performed when the AutoPing is
triggered.
Description
Sets the password of the User or Administrator.
User Manual
Admin
Fact Def
Yes
Yes
0.0.0.0
Yes
10
Yes
3
Yes
AND
Yes
None
Admin
Fact Def
Yes
user | admin
18
Advertisement
Table of Contents
