Setting The Ip Address - Ametek Surgex SA-20-AR User Manual

______________________________________________________________________________
• Manage
o Open Browser: Opens the web browser interface for the selected AR.
o Upgrade Firmware: Starts the Firmware Upgrade dialogue.
Firmware Upgrade requirements:
- Valid firmware file.
- Administrative login credentials.
- "Upgrade Enable" must be set to yes, set via web page or CLI.
• Set
o IP Address: Changes the IP address of the selected AR.
o Factory Defaults: Return the selected AR to a Factory Default state. This action must
be performed within the first 2 minutes after powering up the unit.
o Local Address: Select the IP address to Discover on. This may be necessary for
computers with multiple network connections.
• Exit
o Exits the DMU program.
• Help
o Online Help: Opens a web browser to online help resources.
o About: Displays DMU version information.

Setting the IP Address

ARs are configured with a DHCP assigned factory default IP address.
To set the AR's IP address using one of the following methods, the computer and AR must be on
the same local network.
o DMU: Follow the steps in the preceding subsection to set the IP address using the
Device Management Utility (DMU).
o CLI: These are the basic commands to set the network parameters. After setting these
parameters, the AR will need to be rebooted for the settings to take effect. Any command
that requires rebooting of the AR will provide a prompt to do so. All commands may be
entered as required before rebooting. Manually specifying the IP address via CLI
automatically sets the address as static.
© 2019 AMETEK Electronic Systems Protection | Technical Support 1-800-645-9721 | surgex.com
SA-20-AR User Manual
6