Setup Pages; Device - Ametek Surgex SA-20-AR User Manual

______________________________________________________________________________

Setup Pages

Setup pages are only available while logged in with Administrator credentials. Press Save to save
the new settings. If the new settings require the AR to be rebooted, a Reboot button will appear
at the bottom of the page. Settings requiring reboot will not take effect until the unit is rebooted.
o Device
• Location ID: Specifies a name label (up to 20 characters) that will be displayed at
the top of all pages. Assigning unique names is helpful for management of
multiple units.
• Cycle Time: Specifies the length in seconds of a power cycle (1-999 seconds).
This is the amount of time the outlet will temporarily be On or Off, depending on
the initial outlet state.
• Disable Off: When checked, removes the Power OFF button from the Status and
Control page.
• Upgrade Enable: Enables the ability to upgrade the firmware of the AR.
• Auto Logout: Specifies the inactivity timer duration in minutes (0-99 minutes). If
there is no activity after the specified amount of time, the user will be
automatically logged out. Setting the timer duration to 0 disables the timeout
feature.
• Enable Security Timeout: When unchecked, disables the 2-minute window for
setting IP address and factory defaults via DMU.
Important: As the AR allows only one web user logged in at any time, use
caution when disabling the timeout feature, as it is possible to lock out other
users by forgetting to log out. Closing the web browser will not log the user
out and may lock out web access. In this situation it will be necessary to
access the AR via telnet and reboot the unit.
© 2019 AMETEK Electronic Systems Protection | Technical Support 1-800-645-9721 | surgex.com
SA-20-AR User Manual
9