Emerson Liebert ISWEBRT3 User Manual page 26

The main screen gives access to these functions:
• Set IP Address—This function allows setting up the IP address, Gateway address and Subnet
Mask parameters.
• Set SNMP MIB System—This function allows setting up the MIB system group parameters.
• Set SNMP Access Control—This function allows setting up the Manager IP, Community,
Access Permission.
NOTE
The configuration of Set SNMP Access Control is used only for SNMP Network Manager.
• Set SNMP Trap Notification—Add the IP address of trap receivers, community string (match-
ing the NMS), type of traps to receive and whether the Destination IP Address should receive
traps to this list.
NOTE
The configuration of Set SNMP Trap Receiver is only used for SNMP Network Manager.
• Set UPS Properties—This allows setting up the Communication Type of UPS, UPS Device
Name and Battery Replacement Date.
• Set UPS Devices Connected—This section allows setting up the connected devices name, rat-
ing and whether the device is connected.
• Set System Time & Time Server—This allows setting up the System date, time and two time
servers.
• Set Web and Telnet User Account—This is allows setting up the user accounts' authority.
• Set E-mail—This is allows setting up the e-mail accounts to receive power event notification for
emergency management.
• Reset Configuration to Default—Set all values to their default values.
• Save & Reboot—Save the current configuration data, including any changes made, and reboot
the Liebert IS-WEBRT3 card.
• Exit Without Saving—Exit; no configuration changes will be made.
22
Telnet—Remote Monitoring