Sense[N]:<Function>:Average:count - Keithley 2280 Series Reference Manual

Series 2280 Precision DC Power Supply Reference Manual
:SENSe[n]:<function>:AVERage:COUNt
This command sets the number of measurements that are averaged when filtering is enabled for the specified
function.
Type
Command and query
Usage
:SENSe[n]:<function>:AVERage:COUNt <value>
:SENSe[n]:<function>:AVERage:COUNt?
:SENSe[n]:<function>:AVERage:COUNt? DEFault
:SENSe[n]:<function>:AVERage:COUNt? MINimum
:SENSe[n]:<function>:AVERage:COUNt? MAXimum
[n]
<function>
<value>
Details
The filter count is the number of readings that are acquired and stored in the filter stack for the
averaging calculation. When the filter count is larger, more filtering is done and the data is less noisy.
Example
SENS:CONC:AVER:WIND 0.1
Also see
:SENSe[n]:<function>:AVERage[:STATe]
:SENSe[n]:<function>:AVERage:TCONtrol
:SENSe[n]:<function>:AVERage:WINDow
077085503 / March 2019
Affected by
Recall settings
Instrument reset
Power cycle
Channel number: For single-channel instruments, the value is 1
The measurement function to which this setting applies:

Concurrent: CONCurrent[:DC]

Current: CURRent[:DC]

Voltage: VOLTage[:DC]
The number of readings required for each filtered measurement (2 to
100)
(on page 7-62)
(on page 7-63)
(on page 7-64)
Section 7: SCPI command reference
Where saved
Save settings
Set the average filter window as 0.1%.
Default value
10
7-61