Configuring The Sensor(S) - Emerson Rosemount 644 Reference Manual

Reference Manual
00809-0200-4728, Rev RA
2.6.2

Configuring the sensor(s)

Sensor configuration includes setting the information for:






Configuring the sensor(s) with a Field Communicator
The Configure Sensors method will guide you through the configuration of all necessary
settings associated with configuring a sensor including:
For a full list of Sensor Types available with the 644 and their associated levels of accuracy, see
Table A-2 on page
From the HOME screen, enter the Fast Key sequence.
Device Dashboard Fast Keys
Configuring sensor(s) with AMS Device Manager
1.
2.
3.
4.
Configuring the sensor(s) with LOI
Reference the below image for guidance on where to find Sensor Configuration in the LOI menu.
Figure 2-5. Configuring Sensors with LOI
* Available only if option code (S) or (D) is ordered.
Configuration
Sensor Type
Connection Type
Units
Damping values
Sensor Serial Number
RTD 2-Wire Offset
98.
Right click on the device and select Configure.
In the left navigation pane select Manual Setup and select the Sensor 1or Sensor 2 tab
depending on the need.
Individually select the Sensor Type, Connection, Units and other sensor related
information as desired from the drop down menus on the screen.
Select Apply when complete.
VIEW CONFIG
SENSOR CONFIG SENSOR CONFIG
UNITS
RERANGE
LOOP TEST
DISPLAY
EXTENDED MENU
EXIT MENU
2, 1, 1
VIEW SENSOR VIEW SENSOR
SENSOR CONFIG SENSOR CONFIG
BACK TO MENU
EXIT MENU
Section 2: Configuration
April 2015
VIEW S1 CONFIG
VIEW S2 CONFIG*
BACK TO MENU
EXIT MENU
SENSOR 1 CONFIG
SENSOR 2 CONFIG*
BACK TO MENU
EXIT MENU
17