Table of Contents
Advertisement
The alarm board is located besides the front system fans inside the chassis. Its sys-
tem detecting function can be used to monitor computer system status, including
temperature, fan, power and HDD status. In case any error occurs to the system, the
alarm board will raise the alert through sound alarm and LED indicator.
The alarm board will raise the alarm if:
1.
A failure happens on a cooling fan.
2.
The temperature inside the chassis goes too high.
When a sound alarm occurs, press the alarm reset button on the front panel to stop
the alarm. And then you should immediately repair the system.
Note!
With different system layout, you can configure alarm board by H/W
switch to prevent incorrect alarm raised. Please refer to "Switch Setting"
section for detailed information.
For remote management function. You will need to install SUSIAccess. Then you will
be able to monitor system fan speed, system temperature, CPU temperature and
voltage. You can also set your own alarm standard under SUSIAccess according to
your demand. For detailed information. Please refer to user guide of SUSIAccess.
报警板位于机箱内前方系统风扇的旁边。报警板具有系统检测功能，可以监视整个计
算机系统的状态，包括：温度状态、风扇、电源和 HDD 运行。一旦系统发生任何问题，
报警板将通过声音警报和 LED 指示灯进行报告。
报警板将在下列几种情况下发出声音警报：
1.
任一冷却风扇发生故障；
2.
机箱内部温度过高。
发出声音警报时，按下前面板上的报警复位按钮即可将其停止，然后需采取措施进行
修复。
注：
根据不同的系统布局，您可以通过硬件拨码开关来设置报警板，以免误
发出声音警报。详细信息请参考 " 开关设置 "。
若要使用远程管理功能，您需要安装 SUSIAccess。您将能够监控系统风扇速度、系统
温度、CPU 温度以及电压。您也可以根据需要在 SUSIAccess 下定制报警标准。更多详
细信息，请参考 SUSIAccess 用户指导。
ACP-4020 User Manual/ 用户手册
30
Advertisement
Table of Contents
