SR Research EyeLink 1000 Installation Manual page 7

Figure 7-1: EyeLink 1000 Long Range Mount affixed to a Desktop Base (left) and
pictured with a variety of lenses and Tripod Adapter (right) ................................. 40
Figure 7-2: Mounting Bar and Clips-note Guide Pins on the Camera Head clip (left)40
Figure 7-3: Fiber Optic Camera Head with lens (left), attached to the Camera Head
Bracket (center), Guide Holes in the Camera Head Bracket accept Guide Pins from
Camera Head Clip (right) ........................................................................................... 42
Figure 7-4: Bracket in the Level Position (left) and Angled (right) - without the Camera
Head (top) and with the Camera Head (bottom)...................................................... 43
Figure 7-5: Illuminator attached using two brass thumbscrews (left), or single
thumbscrew (center), rotates around the Mounting Bar when its knob is released
to adjust tilt (right) ..................................................................................................... 43
Figure 7-6: Tripod Adapter (left), Desktop Base (middle) and Mounting Bar attached to
the Tripod Adapter using Two Brass Bolts (right)................................................... 44
Figure 7-7: Male DB-9 connector (left-to-right), gender changer with female connector
showing, BNC connectors, LEMO connectors, and Battery System..................... 45
Figure 7-8: Focusing the Illuminator.............................................................................. 47
Figure 7-9: Pointing the Camera - a visible illumination boundary indicating poor
lighting of the left portion of the camera's view (left) and a fully illuminated target
indicating intense and uniform illumination (right) ............................................... 49
Figure 7-10: Screen Mount used in conjunction with the Elekta Neuromag screen (left)
and a custom-built wood-frame screen (right) ........................................................ 52
Figure 7-11: Tray Mount with optional screen for Siemens family of scanners (left),
Screen Mount (middle), and Siemens Allegra short bore mount (right) ............... 53
Figure 7-12: Tray Mount for Siemens family of scanners pictured from above with
optional screen (left), from behind with screen (top-middle) and configured for
user-supplied screen (bottom-middle), riser block on screen (top-right) and from
above (bottom-right) ................................................................................................... 55
Figure 8-1: Booting into the EyeLink Partition.............................................................. 65
Figure 8-2: Host Application Camera Setup Screen ..................................................... 66
Figure 8-3: Host PC Set Options Screen ........................................................................ 66
Figure 8-4: Measuring screen_phys_cords..................................................................... 69
Figure 10-1: High-Speed Frame Grabber....................................................................... 76
Figure 10-2: D-Link Ethernet Card ................................................................................ 77
Figure 10-3: Analog Card ................................................................................................. 77
Figure 11-1: License Code Entry..................................................................................... 78
Figure 11-2: Enable System Commander ...................................................................... 79
Figure 11-3: Select Partitioning then Manual Partitioning .......................................... 79
Figure 11-4: Partition Selection and Resizing ............................................................... 80
2005-2010 SR Research Ltd.
vii